This is a Hitec High Voltage HSB-9485SH Brushless Steel Gear Digital Servo, designed with Hitec’s durable steel gears and impressive brushless motors with the HSB-9485SH bringing immense torque.
Features:
- Programmable 12-Bit PWM Digital Amplifier
- Custom Long Life Brushless Motor
- 1M Cycle Long Life Potentiometer
- Constant Output Torque
- Wide Operating Voltage (5 ~ 9 Volts DC)
- Dual Ball Bearing Supported Output Shaft
- Dust Resistant and Splash Proof Case
- 25-Tooth Output Spline
- Nylon Reinforced Plastic Case
- Ultra Low Power Consumption
Programmable Functions:
- End Point Adjustments
- Direction
- Fail Safe
- Dead Band
- Speed (Slower)
- Soft Start Rate
- Data Save / Load
- Program Reset (From File)
Accessories:
- Steel Gears Set (Link)
- Metal/Karbonite 1st Gear Set (Link)
- Plastic Case Set (Link)
- Applicable Horns (Link 1 • 2 • 3)
Performance Specifications:Operating Voltage Range:(Volts DC) 6.0V ~ 7.4VSpeed:(Second @ 60°) 0.18 ~ 0.15Maximum Torque Range oz./in.:361Maximum Torque Range kg./cm.: 26.0Current Draw at Idle:30 mANo Load Operating Current Draw: 430 mAStall Current Draw:1,100 mADead Band Width: 1 µs
Physical Specifications:Dimensions (Inches):1.57 x 0.78 x 1.45Dimensions (Metric): 40.0 x 20.0 x 37.0Weight (Ounces):2.19Weight (Gram): 62.0Circuit Type:EBL DigitalMotor Type: BrushlessGear Material:SteelBearing Type:Dual Ball BearingOutput Shaft (type / Ømm): H25TCase Material: PlasticDust/Water Resistance Splash Proof: YesConnector Gauge (AWG)(Strand Count):20/80
Limited Warranty:
Hitec Servo Warranty: Each Hitec servo is backed by a limited two-year warranty from the date of purchase. Hitec RCD USA, INC. shall REPAIR OR REPLACE, at Hitec RCD, INC., defective equipment covered by this warranty, otherwise the purchaser and/or consumer is responsible for any charges for the repair or replacement of the product.
This product was added to our catalog on November 25, 2019
Reviews
There are no reviews yet.