This is a Hitec High Voltage D945TW D-Series Ultra Torque Titanium Gear Digital Servo, designed using Hitec’s redesigned, cutting edge, custom engineering. Combining industry leading high-resolution, state-of-the-art ultra-response technology with a 32-bit MCU and 12-bit ADC for unprecedented programmability and flexibility, these servos deliver significantly smoother movement. The speedy, powerful line operates on a wide 4.8 ~ 8.4 voltage range, allowing use with any common battery chemistry without the need for adapters or regulators. Featuring Hitec’s industry standard 25-tooth output spline with 3mm hex screw, each D-Series servo brings monster performance never known before in the market.
Features:
- Programmable PWM Digital Amplifier
- 32-Bit MCU with 12-Bit ADC Circuitry
- 4096 Resolution
- 1M Cycle Long Life Potentiometer
- Wide Operating Voltage (4.8 ~ 8.4 Volts DC)
- Dual Ball Bearing Supported Output Shaft
- 25-Tooth Output Spline
- Coreless Metal Brush Motors
- Nylon Reinforced Plastic Upper and Lower Case
- Diamond Cut Aluminum Heat Sink Center Case
- Dust Resistant and Splash Proof Case
Programmable Functions:
- End Point Adjustments
- Direction
- Fail Safe
- Dead Band
- Speed (Slower)
- Soft Start Rate
- Overload Protection
- Data Save / Load
- Program Reset
Specifications:
Operating Voltage Range (Volts DC):4.8V ~ 6.0V ~ 7.4V
Speed (Second @ 60°):0.16 ~ 0.12 ~ 0.10
Maximum Torque Range oz./in.:194 ~ 250 ~ 319
Maximum Torque Range kg./ cm.:14.0 ~ 18.0 ~ 23.0
Current Draw at Idle:30 mA
No Load Operating Current Draw:470 mA
Stall Current Draw:6,200 mA
Dead Band Width:1 µs
Dimensions (Inches): 1.57 x 0.79 x 1.50
Dimensions (Metric): 40.0 x 20.0 x 38.0
Weight (Ounces): 2.4
Weight (Gram):68.0
Circuit Type:32bit Programable Digital
Motor Type: Coreless Metal Brush
Gear Material:Titanium
Bearing Type: Dual Ball Bearing
Output Shaft (type / Ømm): H25T
Case Material: Plastic/Aluminum
Dust/Water Resistance Splash Proof:Yes
Connector Gauge (AWG)/Strand Count: 20/80
Accessories:
- Titanium Gears Set | Link |
- Metal/Karbonite 1st Gear Set | Link |
- Plastic/Aluminum Case Set | Link |
- Applicable Horns | Link 1 • 2 |
Limited Warranty:
Hitec Servo Warranty: Each Hitec servo is backed by a limited two-year warranty from the date of purchase. Hitec RCD USA, INC. shall REPAIR OR REPLACE, at Hitec RCD, INC., defective equipment covered by this warranty, otherwise the purchaser and/or consumer is responsible for any charges for the repair or replacement of the product.
This product was added to our catalog on November 25, 2019
Reviews
There are no reviews yet.